Enabling Lock Y-Axis for one app

[3Dmented]

I'm a newbie to XMBC, and this question may make that obvious:

I've successfully been able to lock the Y-axis using a Modifier key (Ctrl) in the Default profile settings. Now I would like it to occur only when using Photoshop.

To do this, I made a copy of the Default profile where I had the working settings, and identified Photoshop as the app for the copy, and saved. Then I went back into the Default settings and 'undid' my working settings - unchecking 'Enable modifier keys' and setting Lock Y-Axis back to 'None' for the control. When I did so, and went back to my Photoshop app settings, it changed there too. When I re-checked the checkbox to "Enable Modifier keys" and reassigned Lock Y-Axis back to 'Control' in the Photoshop profile, sure enough, my Default settings profile reflected the same change.

What am I missing? How do I enable and assign Lock Y-axis to a Control for just one app (Photoshop in this case)? Is there another setting or checkbox other than 'Enable modifier keys..." that I need to set for each profile to control when that occurs? I realize that the controls I am using are in the "Global Settings" area, so would like to know if there is a better method or settings I need to set in each profile to control this.

And yes, I am pressing OK and applying the setting on the main screen after each change...

Any help appreciated.

[phil]

You are missing the fact that modifier and global hotkeys are all global. They are not profile specific.
However, there is an option per profile (in the options tab) to enable axis locking (or not).
So leave the global layer modifiers active and setup, and turn off the "Enable axis locking modifier keys" on the default profile.

Thanks,
Phil

[3Dmented]

Thanks for the speedy response, Phil.

...So leave the global layer modifiers active and setup, and turn off the "Enable axis locking modifier keys" on the default profile.

Unfortunately, it did not seem to make a difference when I unchecked "Enable axis locking modifier keys" under the Default profile Options tab. My Y-axis can still be locked by holding down Ctrl everywhere.

I'm using XMBC v2.17 on Windows 7 if that means anything.

[phil]

Oh thats odd, I'll add it to my list of things to look at!